UV LED strip for DIY Curing Chamber : r/resinprinting
UV resin cured curved. Here you can see the demolded one curved and the one still in the mold popping out because of the curve. : r/ResinCasting
Would an UV lamp work for recycling resin water? : r/resinprinting
After UV curing clear resin prints, carefully use a heat gun to completely remove the yellowing that occurs. Left side is the exact same print, but reheated with a heat gun. :
Rate my set up, UV curing station. Question: how far away should lights be? : r/resin
Got a resin printer recently and and looking for a UV light to cure the prints, would either of these be fine? : r/resinprinting
why is my UV resin tacky/not hard? : r/ResinCasting
My take on a DIY UV curing chamber. : r/ElegooSaturn
Would this be a good UV lamp if not what UV lamp should i get : r/3Dprinting
My prototype resin curing boxing : r/resinprinting
16 pin uv lights for curing the inside of my models!! Works wonders, cost $15 bucks : r/resinprinting
I have one aquarium uv light lying around, can the resin be cured under this setup? : r/AnycubicPhoton
Will this work for curing UV resin? : r/AnycubicPhoton
Used an old locker as a curing station. A thought occured. What is the ideal power of UV light to use? Too powerful cause warping? : r/resinprinting
First attempt at “freezing” UV curing resin mid drip. I'm pretty happy with the results. (WIP hero bases for my Suppressors) : r/Warhammer40k
My $16 resin print curing “station” : r/3Dprinting
will this be enough to cure resin prints? : r/3Dprinting
I got a vintage tanning lamp (as best as I can tell) at goodwill, but how do I know if it uses real UV rays? : r/3Dprinting
Gluing resin together : r/resinprinting
Got a resin printer recently and and looking for a UV light to cure the prints, would either of these be fine? : r/resinprinting
My simple curing station & question about cure time : r/resinprinting
Will this cure? : r/resinprinting
